HP-01 recalibration

All other HP calculators

HP-01 recalibration

Postby cmj1047 » Sun Jan 18, 2009 5:20 pm

I have seen one time in some forums and typically in HP Forum archive 13 in May 2003 some questions about how to recalibrate the HP-01 clock and some other questions about the quartz frequency, etc...
As I have got one of those watch I was trying to find answers.

I will say that answers are in HP journal December 1977

According to schematic page 4:
Quartz is 38.4 kHz
C3 adjustable capacitor position can be seen in page 7 figure 7.3
Physical position can be deducted from photographs
Looking at the back inside of the watch, find the hole (1.8 mm diameter) where it can be adjusted.

See attached photograph.

A small isolated square ended tool has to be used to perform the adjustment. From an old small screwdriver I build a such tool and it is approximately a square of 0.65 mm. I am not sure about isolation but I have done it just in case.

I hope this information will be useful to others.

Regards
Christian
Attachments
HP-01 internal_compressed.jpg
HP-01 internal_compressed.jpg (26.38 KiB) Viewed 22112 times
Last edited by cmj1047 on Tue Nov 15, 2011 2:55 pm, edited 2 times in total.
cmj1047
..
..
 
Posts: 4
Joined: Thu Jan 08, 2009 5:10 pm

Re: HP-01 recalibration

Postby jotne » Sun Jan 18, 2009 8:50 pm

I do have two HP-01, but since I do only use them know and then, I do not care if they are not accurate.
Mine seems to be quite accurate.
But thanks for the tip.
HP41CX with CCD module . HP41CV . HP42S + many other HP calculators
User avatar
jotne
Site Admin
Site Admin
 
Posts: 69
Joined: Mon Nov 24, 2008 6:52 pm


Return to Other HP Calculators

Who is online

Users browsing this forum: No registered users and 1 guest