I'm trying to read the notes on the Instruction Set, but they are hard to read. I tried sending the pages through an OCR program, but the results were even harder to read. So, I have taken to re-writing the notes myself.
Is anyone interested in a copy when I'm done? I'm using MS Word, but I should be able to produce a copy in plain .TXT format.
I'm aware the Instruction Set is based on a 10-bit instruction size. So, I'm also trying to translate the Octal code [1333] into Hex [244].
However, when I get 2-word instructions, I'm not sure whether to use [244 244] or [ 4 4444] ie. compact the strings.
Any suggestions / recommendations?